Request a Replacement Product

If this is your first warranty claim within 12 months of installation and your pump has been installed correctly, in-line with our warranty guidelines, we will send you a replacement out free of charge.

All you need to do is supply installation information and we will be in touch to arrange this for you. Terms and conditions apply.

* Required Fields

Name*

Email*

Telephone*

Address line 1*

Postcode*

Serial Number*

What is the pump supplying?

We need to know what outlets the pump is boosting the water to.

Please provide photos of all the outlets the pump is boosting the water to, such as a shower head, tap, toilet, bath or wash basin.

If you’re not sure if the pump is supplying a particular outlet, you can check by turning on the outlet and if the pump turns on then we know the pump is supplying this outlet.

A photo of the overall hot water cylinder installation.

Stand back from your hot water cylinder and take a photograph of the entire cylinder including the surrounding area and pipework. Please remove anything obscuring the view, such as towels or boxes.

A close up photo of the top of the hot water cylinder including pipework.

Please take this from the dome of the hot water cylinder and above.

A photo of the top connection on the hot water cylinder.

A photo of any side connections on the hot water cylinder.

A photo of the hot water cylinder temperature control.

Take a close-up photo of the temperature controls for the hot water cylinder. E.g. Thermostat on cylinder, immersion or thermostatic mixing valve.

A photo showing the pump in its location, including the hoses.

A photo of the electrical supply to the pump.

E.g. Plug socket or fused spur.

A photo of the serial number label on the pump.

Depending on the type of pump, the serial number label will either be found on the top of the pump or on the vessel attached to the top of the pump.

The label will look like the images shown below, the highlighted digits are the serial number. Please be aware the colour and size may vary.

Only required if the pump is located above the hot water cylinder.

The height (in mm) between the base of the cold-water storage tank and the top of the pump.

This measurement needs to be taken from the base of the cold-water storage tank to the top of the electrical box on the pump, not the pressure vessel.

The height (in mm) between the base of the cold-water storage tank and the top of the hot water cylinder.

If they are on different floors measure the height from the top of the hot water cylinder to the ceiling, and then measure from the floor to the base of the cold-water storage tank and add together.

A photo of the overall cold-water storage tank including pipework.

If they are on different floors measure the height from the top of the hot water cylinder to the ceiling, and then measure from the floor to the base of the cold-water storage tank and add together.

A photo of the pipework linking multiple tanks together.

Only required if the system includes linked cold-water storage tanks.

For square or rectangular cold-water storage tanks:

A photo of the inside of the cold-water storage tank including the ball valve pipework.

For square or rectangular cold-water storage tanks:

The width and length of the cold-water storage tank and the depth of the water.

For round cold-water storage tanks:

A photo of the inside of the cold-water storage tank including the ball valve pipework.

For round cold-water storage tanks:

The diameter of the cold-water storage tank and the depth of the water.